Skip to main content

v0.13

Minor Versionm

by Alkesh Dhak

    • If installing an IOX accessory please use the correct guide from here before performing the steps below.

  1. Plug in the GO device.
    • Plug in the GO device.

  2. Start Vehicle.
    • Start Vehicle.

    • Verify LED pattern.

    • The device emits 2 quick beeps every 60 seconds during setup. Once all three LEDs turn solid you will hear 10 quick beeps.

  3. Secure the device to the harness using the included black serialized cable tie.
    • Secure the device to the harness using the included black serialized cable tie.

    • Trim any excess cable tie flush.

  4. Route device and harness to mounting location as needed.
    • Route device and harness to mounting location as needed.

    • Ensure cable does not interfere with any moving parts.

    • Secure harness as needed with cable ties.

    • Secure device using 2 cable ties.

    • To ensure reporting quality the device must be secured with no free movement!

    • Device must not be secured with bottom side facing in direct contact of metal!

    • To ensure reporting quality the bottom of the device must have line of sight to the sky!

    • Lines of sight through plastics, glass, and composites are generally acceptable.

Finish Line

Alkesh Dhak

Member since: 04/07/2022

62 Guides authored

Team