Skip to main content

v1.0

Major VersionM

by Alkesh Dhak

    • All in-vehicle devices and related cabling must be securely fastened and kept clear of all vehicle controls, including gas, brake and clutch pedals.

    • This requires the use of a cable tie when securing the device or any extension harness to the OBD connector, securing both sides of the harness. If you do not use a cable tie, vibration in the vehicle can lead to a loose connection which could indirectly cause the vehicle’s engine computer to fail, loss of vehicle control and cause serious injury.

    • Inspect devices and cabling regularly to ensure all devices and cabling continue to be securely attached.

    • If at any point after an in-vehicle device is installed a warning light illuminates on the vehicle dash or the vehicle stalls or has a marked drop in performance, shut off the engine, remove the device, and contact your reseller. Continuing to operate a vehicle with these symptoms can cause loss of vehicle control, and serious injury.

  1. Enter Installer information .
    • Enter Installer information .

  2. Use the Click here if you removed an old device button.
    • Use the Click here if you removed an old device button.

  3. Enter device serial number of the new device.
    • Enter device serial number of the new device.

    • Enter device serial number of the removed device.

    • Use the barcode scan feature when possible.

  4. Wait with engine on for the Device status to show as pass. If the device status shows as failed verify the LED status and cycle the engine off/on.
    • Wait with engine on for the Device status to show as pass.

    • If the device status shows as failed verify the LED status and cycle the engine off/on.

    • Select refresh to check status again.

    • Refer to this guide for detailed instruction.

  5. Enter all applicable vehicle information.
    • Enter all applicable vehicle information.

    • Read and acknowledge Geotab's Privacy policy.

  6. When the installation check is completed  with out error you will see a Success! result. Select New installation to check another installation or exit when done.
    • When the installation check is completed with out error you will see a Success! result.

    • Select New installation to check another installation or exit when done.

    • When the installation check is completed with errors you will see an Error result.

    • Select New installation to check another installation or exit when done.

    • For the latest version of the Limitations of Use, please visit: http://goo.gl/k6Fp0w

    • Your in-vehicle devices must be kept clear of debris, water and other environmental contaminants. Failure to do so may result in units malfunctioning or short-circuiting, that can lead to a fire hazard and cause loss or serious injury.

    • Do not attempt to remove the devices from the vehicle in which they are originally installed for installation in another vehicle.

    • Not all vehicles share compatibility, and doing so may result in unexpected interactions with your vehicle, including sudden loss of power or shutdown of the vehicle’s engine while in operation or cause your vehicle to operate poorly or erratically and cause serious injury and/or vehicle damage.

    • This product does not contain any user-serviceable parts. Configuration, servicing, and repairs must only be made by an authorized reseller or installer. Unauthorized servicing of these products will void your product warranty.

    • The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as follows:

    • Hereby, Geotab (Address: 2440 Winston Park Drive, Oakville, Ontario L6H 7V2, Canada, Phone number: 1 (877) 436-8221) declares that the radio equipment type ‘telematics device’ is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available here.

    • WARNING: Cancer and Reproductive Harm

Finish Line

Matthew Reilly

Member since: 01/10/2022

42 Guides authored

Team