Rexroth CS230

Written By: Jason Fox (and one other contributor)

Difficulty

Moderate

Requirements

A CS230 proprietary cable is required to connect the CS230 to the IOX-WRKS Primary Port.
Controller damage possible.
CS230 data cable is ignition powered ONLY if unit is non-AC model.
CS-230 = Requires cable to be ignition powered.
CS-230-AC = DO NOT power cable

Ensure the IOX-WRKS has the correct controller configuration loaded before proceeding to verification / simulation mode.

Turn the CS230 on and set the Application and spread rates using the labelled knobs on the controller.
The display could be showing a number of parameters depending on it’s programming. Use the Increment buttons to toggle through the settings.
“ARS” is Application Rate Setting (Usually in Lbs/mile), “AR” is actual rate which should be zero due to the vehicle not moving.
Controller data should be captured when the unit is on, there are no errors displayed, and it is in operation mode with rates set.

With the programming key and always starting with dials at zero before entering the programming mode, you can check the following:
Set the rate and application dials to access the parameter of interest. For example spread 9, and application 9 accesses Parameter 99.
Parameter 99 displays the Software Version.
Parameter 62 the GPS data format, which should be set at zero
Using the increment and blast buttons will allow a change and save of the new value.
Please do not change any settings without first confirming with the customer !