Parker IQAN - MDL

Custom cable connection required.

Parker controller integration requires CANBUS programming to available CANBUS lines.

This must be completed by the upfitter. They will identify which CANBUS lines we connect to the CANBUS on the IOX-WRKS. IOX-WRKS.

Ensure the IOX-WRKS has the correct controller configuration loaded before proceeding to verification / simulation mode.

Press F1 (Setup) on the main operator screen to obtain the setup page

Press F1 (ground speed) to enter security code / enter simulated ground speed

Enter security code using the selector knob (if applicable) - this will be supplied by the customer.

Using the selector knob - change the “ground speed” setting to “Simulated” and press the knob to make the change.

Using the selector knob - Set speed to about 30km/h.

Turn the Control head to “activated” by pressing the “Main power” button - it will illuminate from Red to Green.

Select a material and spread rate using the “Granular”, “Lane” and “Liquid” selector knobs on the control head.

You will see these changes reflected on the screen under “Granular Rate”, “Spinner” and “ Liquid rate”

Verify data flow.

Switch the controller off at the control head and return it to “ground speed” setting on the setup page.

Never leave a controller in simulation mode!