v1.1

Minor Versionm

by Jason Fox

Marwis Meteorological Sensor

Written By: Jason Fox
  • Comments: 0
  • Favorites: 0

Difficulty

Difficult

Sections

1

  1. Marwis cable connections must be soldered and insulated with heat shrink.

    • Marwis cable connections must be soldered and insulated with heat shrink.

    • A single 120 ohm termination resistor is required.

  2. White Marwis to GND Brown Marwis to +12vdc ignition Pink Marwis CAN+ to IOX-WRKS Yellow CAN+

    • White Marwis to GND

    • Brown Marwis to +12vdc ignition

    • Pink Marwis CAN+ to IOX-WRKS Yellow CAN+

    • Grey Marwis CAN- to IOX-WRKS Green CAN-

    • Be certain to install120ohm Termination Resistor between the CAN+ and CAN- connections as shown.

    • There will be nothing connected to the Red, Blue, Yellow, or Green leads on the Marwis cable.

Finish Line

Author

Jason Fox

Member since: 09/14/2023

32 Guides authored

Team

Field Service Specialists Member of Field Service Specialists

8 Members

93 Guides authored