IOX-ALERT Prerequisite

The IOX-ALERT has a single BLACK wire that must be connected to an external trigger button.

This wire can either be connected to a momentary contact (HDW-IOXBUTTON) or a ON/OFF toggle switch.

Always consult with the customer to determine the appropriate mounting location of the HDW-IOXBUTTON.

Ensure the mounting location is within reach of the driver.

The HDW-IOXBUTTON will require a 1/2" (13.6mm) hole to be drilled for mounting.

Use extreme caution when drilling holes. Before drilling, check behind the mounting location to ensure the area is clear of any obstructions or electrical wires/components/airbags.

Mount the HDW-IOXBUTTON button & tighten the supplied nut to no more than 1.5 Nm.

The IOX-ALERT has a single black wire (labelled AUX 1).

Connect it to one of the wires of the HDW-IOXBUTTON.

Connect the second wire of the HDW-IOXBUTTON to a chassis ground using a ring terminal.

You may need to extend the wire from the HDW-IOXBUTTON in order to reach a connection point for the chassis ground.

The wire and the ring terminal are not included in the IOX-ALERT kit and must be supplied by the installer.

Ensure all wire connection are secure.

Route the IOX-ALERT over to the mounting location of the GO device.

Remove expansion port cover on the GO device and plug the 90° Mini-USB connector of the IOX-ALERT into the GO device.

Secure the USB connector using a cable tie.

Do not overtighten the cable tie, as this can damage the USB connector.

Secure excess wiring with cable ties as needed.

Trim any excess cable tie.

Plug the GO Device into the vehicle interface harness.

Refer to the Harnesses Category for installation instructions specific to your vehicle type.