-
-
The Tesla connector is located behind the lower center console panel which is held in with clips.
-
For ease of installation, move both driver and passenger seats to their most forward position.
-
Slide the end of a panel removal tool under the right side of the panel, twist slightly to release the clips, and then remove the panel.
-
-
-
-
-
-
Plug the GO device into the Geotab harness.
-
You should hear 6 beeps, and the Red, Blue and Green LEDs on the GO device should blink.
-
-
-
Using an alcohol-based wipe, clean the bottom of the air vent.
-
Make sure the surface is completely dry before proceeding.
-
Apply double-sided tape to the bottom of the vent as shown.
-
-
Peel off the protective film from the exposed side of the double-sided tape.
-
Attach the antenna side of the GO device the double-sided tape.
-
The GPS antenna is located on the "bottom" of the GO device.
-
Apply firm pressure for 30 seconds.
-
-
Reinstall the removed panels in reverse order, starting with the center panel.
-
Line up the clips and press firmly, locking the panel into place.
-
Take the air vent panel and push the wiring down to prevent it from being pinched by the panel.
-
Line up the clips and firmly press the panel into place.
-
-
! IMPORTANT: Ensure the GO device cable is not pinched.
-
Refasten the two T20 TORX screws.
-
Reinstall the center panel by lining up the clips and firmly pressing them into place.
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.
Preview