HRN GS16K2

Locate & remove the OEM OBDII connector from its OEM location

Identify the adapter required for installation from the parts included in the kit.

See here for general identification

Video example for this step

Install the adapter onto the connector housing

In most cases the groove should be visible once the adapter is completely seated.

Slide the metal clips into the groove to retain the assembly

If the groove is not visible the adapter is likely installed backwards.

Plug the female connector from the T-harness into the OEM OBDII connector

Secure connection with a cable tie

Trim excess cable tie flush

Install the prepared T-harness connector from the first steps into the OEM location

Ensure cable does not interfere with any moving parts

Secure harness as needed with cable ties