v2.2

Minor Versionm

by Jason Fox

EZ GO Golf Cart TXT and RXV

Written By: Jason Fox (and one other contributor)
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Sections

1

  1. Access batteries by lifting seat cushion. Locate true ignition source on the Green wire from the loomed harness that goes to the controller. Connect yellow wire from the HRN-RW03K4 harness to that Green wire using a heat shrink butt connector. Connect the red wire from the HRN-RW03K4 harness to the battery POSITIVE.

    • Access batteries by lifting seat cushion.

    • Locate true ignition source on the Green wire from the loomed harness that goes to the controller. Connect yellow wire from the HRN-RW03K4 harness to that Green wire using a heat shrink butt connector.

    • Connect the red wire from the HRN-RW03K4 harness to the battery POSITIVE.

    • Connect the black wire from the HRN-RW03K4 harness to the battery NEGATIVE.

  2. Access batteries by lifting seat cushion and remove plastic cover to access wires. Locate true ignition source on the Purple wire as shown. Connect yellow wire from the HRN-RW03K4 harness to that Purple wire using a heat shrink butt connector. Connect the red wire from the HRN-RW03K4 harness to the battery POSITIVE.

    • Access batteries by lifting seat cushion and remove plastic cover to access wires.

    • Locate true ignition source on the Purple wire as shown. Connect yellow wire from the HRN-RW03K4 harness to that Purple wire using a heat shrink butt connector.

    • Connect the red wire from the HRN-RW03K4 harness to the battery POSITIVE.

    • Connect the black wire from the HRN-RW03K4 harness to the battery NEGATIVE.

  3. See Wiring Diagram:

    • See Wiring Diagram:

  4. Connect the BeWired+ device as follows: Grey Wire (Ignition) goes to the Yellow Wire of the HRN-RW03K4.

    • Connect the BeWired+ device as follows:

    • Grey Wire (Ignition) goes to the Yellow Wire of the HRN-RW03K4.

    • Pink Wire (Constant Power) goes to the Red Wire on the HRN-RW03K4.

    • Black Wire (Ground) goes to the Black Wire on the HRN-RW03K4.

  5. Attach magnetic feet to the Go Rugged Secure GO Rugged in the under seat compartment using magnetic feet. Plug HRN-RS12A1 into HRN-RW03K4 and into GO Rugged.

    • Attach magnetic feet to the Go Rugged

    • Secure GO Rugged in the under seat compartment using magnetic feet.

    • Plug HRN-RS12A1 into HRN-RW03K4 and into GO Rugged.

Finish Line

Author

with 1 other contributor

Jason Fox

Member since: 9/14/23

137 Guides authored

Team

Field Service Specialists Member of Field Service Specialists

9 Members

310 Guides authored